Lithophane Maker

Photo to 3D print · STL and 3MF

Drop in a photo, pick a shape, and download a lithophane: thin where the photo is light, thick where it is dark, so it shows the picture when a light shines through it. Everything runs on this page; your photo is only uploaded if you make a share link, and it is encrypted first.

Shop

Photo

sample

Or drop or paste one onto the page. It is drawn as it will look with a light behind it:

Shape

Thickness

Shade by

Light through plastic fades exponentially, so even thickness steps crush the shadows. "Light" spaces the thickness so the brightness steps are even instead.

Frame

Adjust photo

Gray from

Crop and turn

Turn

Download

Print it

Share

The photo and settings are encrypted in your browser. The key is in the link after the #, which never reaches the server.

Preview light

Plastic color
Light color

How quickly light fades through your plastic. White PLA is around 1.3 per mm; a more see-through filament is lower.

How it works

The photo is turned to gray and sampled on a grid, one point per "mm per pixel". Each point becomes a thickness between the minimum (white) and the maximum (black). The mesh is closed: a top surface over the grid, walls round the outline, and a flat or smooth back. The relief side faces you in the preview, and the picture reads correctly from that side.

Print in white or natural PLA or PETG at 100% infill (or enough walls that no infill is left), 0.1–0.12 mm layers. Standing up gives the finest detail, because the nozzle draws the picture rather than the layer steps. Flat prints faster. Cylinders and arcs always stand.

A 0.4 mm nozzle draws a line about 0.42 mm wide, so a grid finer than 0.1 mm only makes the file bigger.